Xmk-010 Manual -

Correction: This is normal behavior governed by parameter F3 (Compressor Delay Protection). The controller forces the compressor to wait 3 minutes before restarting to prevent high-head-pressure motor stalls.

Connects to the main power supply (typically 220V). Sensor Input: For the external NTC temperature probe. xmk-010 manual

: Users report it is effective for basic monitoring and equipment control, such as cycling compressors or heaters based on set thresholds. Key Technical Features Functionality Correction: This is normal behavior governed by parameter

Capable of integrating with ERP systems for automated inventory updates Safety & Operational Notices Sensor Input: For the external NTC temperature probe

: Features a digital interface that shows real-time temperature readings in Celsius. Application Versatility

To get the most out of the XMK-010 manual, users should follow these steps:

Press again to confirm and save the new value. The device will automatically return to normal operational view if idle for 10 seconds. Parameter Codes Matrix Parameter Name Description HC Working Mode H for Heating / C for Cooling D / F2 Hysteresis (Differential) The degree variance allowed before triggering the relay. 1°C to 15°C LS / F3 Lower Set Limit Minimum allowable temperature setting bound. -50°C to Set Temp HS / F4 Upper Set Limit Maximum allowable temperature setting bound. Set Temp to +90°C CA / F5 Temperature Calibration Offsets display errors if probe reads slightly high/low. -10°C to +10°C PT / F6 Compressor Delay Time Delays cooling restart to protect against short cycling. 0 to 10 minutes 5. Standard Operational Modes Cooling Configuration (Mode C)