Remove and inspect the spark plug. Clean off carbon deposits with a wire brush. Check the electrode gap (standard is usually 0.6–0.7 mm). Replace the plug if the electrodes are badly eroded.
Tighten the included bolts using the hex wrench provided in your tool kit. Note: Never operate the trimmer without this shield, as it deflects rocks and debris away from the operator. 3. Attaching the Cutting Heads
Slide the ignition switch on the handlebar throttle grip to the position.
Remove and inspect the spark plug. Clean off carbon deposits with a wire brush. Check the electrode gap (standard is usually 0.6–0.7 mm). Replace the plug if the electrodes are badly eroded.
Tighten the included bolts using the hex wrench provided in your tool kit. Note: Never operate the trimmer without this shield, as it deflects rocks and debris away from the operator. 3. Attaching the Cutting Heads denzel dt-52 manual
Slide the ignition switch on the handlebar throttle grip to the position. Remove and inspect the spark plug