Press Start or OK . A progress bar will appear. Crucial: Do not power off the device or remove the USB drive until the process hits 100% and the receiver automatically reboots. Troubleshooting Common Upgrade Failures Root Cause "No File Found" Error Incorrect storage format or directory path.

Before starting, ensure your current firmware is backed up (Dump File) to avoid bricking the device. Format a USB drive to firmware file to the root of the USB drive. Plug the USB into the receiver's front or rear port. Navigate to Menu > Settings > Software Upgrade > USB Upgrade

Perform a "Blind Scan" after the update to restore your local satellite channels. Conclusion

This means the firmware ID does not match your hardware. Double-check if your board is V1.1 and not V1.0 or V1.2.

: Set the Upgrade Mode parameter to AllCode or Total Flash to rewrite the entire system image including the bootloader. Select your target file from the file pathway menu.