Click here to change the date of your preference.
Before you start, be aware of the following:
To program the chip via ISP, connect the corresponding pins from your USBasp programmer to the ATmega162. Refer to the official ATmega162 pinout datasheet to locate these six critical points: USBasp Programmer Pin ATmega162 Target Pin Pin Number (TQFP-44 Package) PB5 (MOSI) MISO PB6 (MISO) SCK RESET VCC (+5V) Pin 17 or Pin 38 GND Pin 6, 18, or 39
Usually included with the USBASP.
This article exists for and for users who:
Manages the hardware-level switching for K-Line and CAN-Bus routing.
To prevent the VCDS software from overwriting the ATmega162 firmware in the future, you must set the lock bits on the microcontroller. In AVRDUDE, set the lock bits to prevent further reading or writing via the ISP. Resolving Potential Complications (FTDI / GAL)
Disclaimer: The contents of this website is the copyright of HT Digital Streams Limited and any downloadable version... thereof, including but not limited to electronic or digital version of newspaper (e-paper) in any format, is intended for personal consumption only. Dissemination, distribution, circulation and/ or publication of any content or e-paper (pdf or otherwise) through any mode and/or on any social media platform without prior authorization/ permission/ license, is strictly prohibited.
Click here to change the date of your preference.
Click here to change the city of your preference.
Click here to change the pages/edition of your preference.
Click here to zoom in the page.
Click arrow button to move to the next page.