Bsmce04u-pp Manual - Better

: 4-axis (X, Y, Z, A) with up to 100KHz pulse frequency per axis.

software. It serves as an interface between your computer and the motor drivers, allowing for precise control of stepper or servo motors via USB instead of an older parallel port. Core Specifications DrufelCNC BSMCE04U Installation Manual bsmce04u-pp manual

If you locate the manual, follow this structure to understand it: : 4-axis (X, Y, Z, A) with up

Connect the positive wire of your to the board’s 24V terminal. : 4-axis (X

: Set "E-Stop" to Port 1, Pin 1 (or as wired) and "Active Low" if using a normally closed (NC) switch.